INSTALLATION
Position the appliance and allow it to stand for two to three hours before it is turned on
for the first time to allow the system to settle. Do not position next to any heat source
e.g. cooker, boiler or in direct sunlight etc.
Allow at least 20cm of space at the top and 10 cm of space on both sides of the
appliance and between the back of the appliance and the wall for adequate air
circulation. The appliance is not designed for recessed installation ("building in").
Install on a good firm level surface, and any unevenness of the floor should be
corrected prior to installation, slight unevenness can be overcome by adjusting the
front feet.
NOTE
NOTE
NOTE: If the appliance is positioned on a carpet, soft floor covering you should
NOTE
readjust the front feet once the appliance has time to settle.
Additional
spacers
Additional spacers
Additional
Additional
spacers
spacers for
There are 2 additional spacers in the bag of the instruction manual. We suggest you
install these 2 spacers to your refrigerator as per the diagram below.
Note, the fitting of these spacers is not essential but will ensure that there is sufficient
space for air circulation and better cooling performance.
OPERATION
This appliance is designed to operate in ambient temperature between 16°C and 32°C.
If these temperatures are exceeded, i.e. colder or warmer, the appliance will not
operate correctly. If the ambient temperatures are exceeded for long periods, the
temperature in the freezer will rise above -18°C and food spoilage may occur.
Remove all packaging materials from the appliance. Wash the inside of the cabinet
with lukewarm water and bicarbonate of soda (5ml to 0.5 litre of water). Dry the
appliance thoroughly.
When you use the fridge for the first time or after defrosting, set the thermostat to the
maximum position for at least 2 hours, and then readjust to the normal position.
All manuals and user guides at all-guides.com
for
better
performance
for
for better
better performance
better
performance
performance
5