Publicidad
Idiomas disponibles
Idiomas disponibles
EN
M A X I M U M R E C O M M E N D E D W E I G H T L O A D S
THIS UNIT IS INTENDED FOR USE ONLY WITH THE MAXIMUM
WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM
WEIGHTS INDICATED MAY RESULT IN INSTABILITY, CAUSING POSSIBLE INJURY.
CAM LOCK SYSTEM OPERATION
HOW THE KNOCK DOWN (KD) ASSEMBLY SYSTEM WORKS
1. Screw the cam bolt into the threaded inserts on the panel. Connect both panels together; making sure
cam bolt goes into the pre-drilled hole on the end of panel for cam lock.
2. Insert the cam lock into the pre-drilled large hole on the panel. Make sure the arrow on the face of
cam lock faces out and points towards cam bolt.
3. Take a Phillips screwdriver and rotate the cam lock clockwise to lock the cam bolt in place.
You are now ready to assemble the KD unit.
MAXIMUM LOAD 200 lb. (90.7 kg)
MAXIMUM LOAD 50 lb. (22.6 kg)
02
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A- Large Top Panel (Qty. 1)
B- Small Top Panel (Qty. 1)
D- Back Panel (Qty. 1)
E- Left End Frame (Qty. 1)
G- Right End Frame (Qty. 1)
(1) Cam Lock (Qty. 8+1 extra)
(2) Cam Bolt (Qty. 8+1 extra)
(4) M6 x 25 mm Bolt
(5) M6 x 50 mm Bolt
(Qty. 2+1 extra)
(Qty. 4+1 extra)
(7) Locator Pin (Qty. 1)
(8) Butt Hinge (Qty. 2)
(10) Locking Caster (Qty. 3)
Hex Wrench (Qty. 1)
Tools required: Hex wrench and open wrench (provided) and Phillips screwdriver (not provided).
C- Fixed Shelf (Qty. 2)
F- Middle End Frame (Qty. 1)
H- Metal Bar (Qty. 2)
(3) M6 x 12 mm Bolt (Qty. 4+1 extra)
(6) M4 x 15 mm Screw
(Qty. 18+1 extra)
(9) Swivel Caster (Qty. 3)
Open Wrench (Qty. 1)
03
Publicidad
