PNI AT198 Manual De Usuario página 2

EN
ringing the 'Wait' flashes and Warm-up of 18 counting down (long time not use its
counting down speed is slow), until 'Wait' disappears, and the 'C' and 'blow' guide you to
have a testing.
3. Blow into the 'Gas Entry', when the 'C' appears, please have a deep breath and
breathe out directly to gas entry for about 3-4S, don't stop until the buzzer rings. Within
3-4cm interval until you see '0.00' flashes and 'Blow' disappear, also a buzzer ring at the
same time.
4. Read the result, after breath out, the LCD would give you the readout of your alcohol
contents, the result would be kept on the screen for seconds, with a buzzer ringing, the
tester cut off the power supply automatically.
5. If a new testing needed, please press the switch button again and repeat the above
steps.
Notification:
1. Avoid any strong shock and drop to keep the tester in careful package or deposit.
2. Do not wipe it with any cleaning agent. If high concentration noise gas exists, the
normal testing would be disturbed.
3, The result may be unreliable for your first test if long time storage, please try second
time.
4. To ensure the testing result, please wait 10 min to take the testing after your drinking.
5. Do not use or store the tester in the environment with aggressive gas (such as chlorine
gas).
6. The working life of the sensor is more than 2 years in the normal operating
environment.
7. To ensure the accuracy of the tester, please make a calibration at least 3 months.
EU Simplified Declaration of Conformity
SC ONLINESHOP SRL declares that Alcohol tester PNI AT198 complies with the
Directive EMC 2014/30/EU. The full text of the EU declaration of conformity is
available at the following Internet address:
https://www.mypni.eu/products/153/download/certifications