McCulloch MT260 Manual Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION: A short or worn wire cuts less
efficiently so, to improve its operation on
subsequent occasions, tap the spool but-
ton lightly on the ground while the trimmer
is running. This will bring about the self-
adjustment of the nylon wire. (Fig. 6)
These operations should be repeated a few times
before starting work to make sure that everything is
functioning properly and to familiarize yourself with the
grass trimmer.
Start off slowly, when you have gained experience, you
will be able to use the grass trimmer to its full potential.
CAUTION: After switching off, the nylon
wire will continue to rotate for a few more
seconds.
OPERATION
1.
Start the grass trimmer before getting close to the
grass to be cut.
2.
Cut the grass by moving the grass trimmer from
right to left and proceed slowly keeping the trimmer
inclined by about 30˚ (Fig.7)
Fig.7
3.
High grass should be cut in layers, always begin-
ning from the top. The cuts should be short (Fig. 8)
Fig.8
4.
Do not cut damp or wet grass. Dry grass will give
excellent results.
5.
Always let the nylon wire rotate at top speed; do
not work in such a way as to overload the trimmer.
6.
Avoid wearing the wire out quickly by knocking
against hard objects (stones, walls, fences etc.).
Use the edge of the guard in order to keep the
edge-trimmer at the right distance (Fig. 9)
CAUTION: Do not use the Grass trimmer
without the guard.
7.
Never pass the grass trimmer over the extension
cable while the grass trimmer is running; make
sure it is always in a safe position behind your
back.
8.
Before starting work, make sure that the area to be
cut is free of stones, debris, wires and any other
objects.
Fig.9
• REPLACEMENT OF THE SPOOL OF NYLON WIRE
(FIG. 10, FIG. 11, FIG. 12)
1.
Disconnect the plug from the socket.
2.
Hold the spool carrier (1) firm in one hand, with the
other unscrew the cover (2) as indicated by the
arrow on the cover itself.
3.
Once this has been removed, extract the finished
spool, clean the inside of the spool carrier and the
cover carefully, making sure not to lose the spring.
Insert this into position in the spool carrie.
4.
Take the new replacement spool (3), insert the
ends of the wires into the holes on the cover, put
into position the spool, keeping the side with the
label facing upward.
5.
Fit everything into the spool carrier by pressing
down and rotating clockwise until locking.
6.
Take the end of the wire which is sticking out and,
by pressing the button, withdraw them by at least
ten centimeters.
7.
In the event of the wire breaking inside the spool,
repeat the replacement operation.
8.
Start the grass trimmer following the instructions in
the "STARTING" chapter.
Fig.10
Fig.11
1
2
3
E
N
G
L
I
S
H
Fig. 12
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mt330Mt375

Tabla de contenido