Publicidad
Step 9
Carefully turn your unit over onto its back edges.
å
Separate the CLAMPS from the LIGHTS by loosening the SCREWS in the CLAMPS.
å
Insert the cords of the LIGHT SET (5D) up through the bottom surface of the TOP (C).
å
Slip a CLAMP over each LIGHT and tighten the screw on the CLAMPS. Fasten the CLAMPS to the TOP (C). Use two
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
Remove the NUTS from the SWITCH and insert the SWITCH into the hole in the top surface of the TOP (C). Turn the hex
å
nut onto the SWITCH with your adjustable wrench and then turn the decorative nut on by hand.
Plug the cords into one another and fasten them to the CORD CLIPS. Screw the bulbs into the lights. Do not plug the cord
å
into an outlet until assembly is complete and you have moved the unit to its fi nal destination.
Switch
Screw
www.sauder.com/services
Nuts
Clamp
Insert the Lights up through the TOP (C).
Light with one cord
5D
C
Screw
408294
BLACK 9/16" LARGE HEAD SCREW
(2 used for the CLAMP)
Light with two cords
1S
Page 13
Publicidad
