Units Installation - Hitachi RPC FSN3E Serie Manual De Instalación Y Funcionamiento

UNITS INSTALLATION

3 UNITS INSTALLATION
!
D A N G E R
• Check to ensure that the accesso.ries are packed with the indoor
unit.
• Do not install the indoor units outdoors. If installed outdoors, an
electric hazard or electric leakage will occur.
• Consider the air distribution from each indoor unit to the space
of the room, and select a suitable location so that uniform air
temperature in the room can be obtained. It is recommended that
the indoor units be installed 2.3 to 3 meters from the floor level. If
the unit is installed higher than 3 meters, it is also recommended
that a fan be utilised to obtain uniform air temperature in the
room.
• Avoid obstacles which may hamper the air intake or the air dis-
charge flow.
• Pay attention to the following points when the indoor units are
installed in a hospital or other places where there are electronic
waves from medical equipment, etc.
• Do not install the indoor units where electromagnetic wave is
directly radiated to the electrical box, remote control cable or
remote control switch.
• Install the indoor units and components as far as practical or at
least 3 meters from the electromagnetic wave radiator.
• Prepare a steel box and install the remote control switch in it.
Prepare a steel conduit tube and wire the remote control cable in
it. Then connect the ground wire with the box and tube.
• Install a noise filter when the power supply emits harmful noises.
• This unit is exclusive non electrical heater type indoor unit. It is
prohibited to install a electrical heater in the field.
• Mount suspension bolts using M10 (W3/8) as size, as shown
below:
For Concrete Slab
150~160mm
Steel
I-Beam
Suspension Bolts Anchor Bolt
(W3/8 or M10)
• Do not put any foreign material into the indoor unit and check to
ensure that none exist in the indoor unit before the installation
and test running. Otherwise a fire or failure, etc., may occur.
4 PMML0320A rev.4 - 08/2016
All manuals and user guides at all-guides.com
Wooden Bar
(60 mm to 90 mm
Square)
Square
Concrete
washers
Nuts
Wooden
Sling Bolt
Beam
(W3/8 or M10)
!
C A U T I O N
• Do not install the indoor units in a flammable environment to avoid a
fire or an explosion.
• Check to ensure that the ceiling slab is strong enough. If not strong
enough, the indoor unit may fall down on you.
• Do not install the indoor units, outdoor unit, remote control switch and
cable within approximately 3 meters of strong electromagnetic wave
radiators such as medical equipment.
• Do not install the indoor units in a machinery shop or kitchen where
vapor from oil or mist flows to the indoor units. The oil will deposit on
the heat exchanger, thereby reducing the indoor unit performance,
and may deform. In the worst case, the oil damages the plastic parts
of the indoor unit.
• To avoid any corrosive action to the heat exchangers, do not install
the indoor units in an acid or alkaline environment.
• When lifting or moving the indoor unit, use appropriate slings to avoid
damage and be careful not to damage the insulation material on units
surface.
• This air conditioner has been designed for standard air conditioning
for human beings. For use in other applications, please contact your
HITACHI dealer or service contractor.
• This appliance must be used only by adult and capable people, hav-
ing received the technical information or instructionsto handle this ap-
pliance properly and safely.
• Children should be supervised to ensure that they do not play with
the appliance.