IMPORTANT
In case you disconnect the device or in case of power failure: Wait for
5 minutes before restarting the device.
Turning on the device
Turn on the device by connecting the plug to a wall socket.
Operate the temperature control, which is located on the control panel at the front of
the unit.
Please also refer to the following chapter "Settings".
Settings
Light
" "button turns on or off the interior light.
LED Display
The display indicates your temperature setting and the actual internal temperature.
• When the device turned on the LED always shows the standard setting 17°C.
Short time after the LED indicates the internal temperature.
Temperature setting
Regulate the internal temperature by pressing the buttons"▲" and "▼" to increases
or decreases the set temperature by 1°C-steps. About 5 seconds after the last button
press the electronic switch automatically and the actual internal temperature will be
indicated in display.
• The temperature range can be regulating between +11°C and +18°C, max. +14°C
below the ambient temperature. The optimal room temperature is approx. +20°C.
• It is recommended that you installed the wine refrigerator in a place where the
ambient temperature is between +16°C - +26°C. When the ambient temperature
around +25°C or less, unit can maintain a temperature range between +11°C -
+18°C.
• If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected. For example, placing in extreme cold or
hot conditions may cause interior temperature to fluctuate. The range of +11°C -
+18°C may not be reached.
• The temperature may fluctuate depending on whether or not the interior light is on
or off or whether the bottles are located on the upper, middle or lower section.
• We recommend always switching off the light.
Storing/Tempering
• Fill the device from the bottom tot he top, this cools the bottles faster.
• The following specifications are only recommendations and are optional:
76