Slope Gauge (Manejo En Pendientes) - Craftsman 138.37097 Manuel Del Operador

SLOPE GAUGE (MANEJO EN PENDIENTES)

(OK)
Figure 1
IF A SLOPE IS TOO STEEP FOR SAFE OPERATION!
IF A SLOPE IS TOO STEEP FOR SAFE OPERATION!
To check the slope, proceed as follows:
1. Remove this page and fold along the dashed line.
2. Locate a vertical object on or behind the slope (e.g. a pole,
building, fence, tree, etc.)
3. Align either side of the slope gauge with the object (See Figure
1 and Figure 2 ).
4. Adjust gauge up or down until the left corner touches the slope
(See Figure 1 and Figure 2).
5. If there is a gap below the gauge, the slope is too steep for safe
operation (See Figure 2 above).
WARNING!
Slopes are a major factor related to tip-
over and roll-over accidents which can result in severe injury
or death. Do not operate machine on slopes in excess of 15
degrees. All slopes require extra caution. Always mow across the
face of slopes, never mow up and down slopes.
All manuals and user guides at all-guides.com
15° Slope
USE THIS SLOPE GAUGE TO DETERMINE
USE THIS SLOPE GAUGE TO DETERMINE
vi
(TOO STEEP)
Figure 2
To check the slope, proceed as follows:
1. Remove this page and fold along the dashed line.
2. Locate a vertical object on or behind the slope (e.g. a pole,
building, fence, tree, etc.)
3. Align either side of the slope gauge with the object (See Figure
1 and Figure 2 ).
4. Adjust gauge up or down until the left corner touches the slope
(See Figure 1 and Figure 2).
5. If there is a gap below the gauge, the slope is too steep for safe
operation (See Figure 2 above).
ADVERTENCIA!
to tip-over and roll-over accidents which can result in severe
injury or death. Do not operate machine on slopes in excess of 15
degrees. All slopes require extra caution. Always mow across the
face of slopes, never mow up and down slopes.
15° Slope
Slopes are a major factor related