Programming Of The Operator - Yale powr 600 Manual De Instrucciones

5. Programming of the operator

Programming of the endpositions
1. PushSET-button as long until„1"appears on the display.
2. Press and keep UP-button pressed until the door reached its correct open
positionBy pressingDOWN-button you can do corrections of the door position
3. Confirm the open position by pressingSET
4. The display now shows2
5. Press and keepDOWN-button pressed until the door reached its correct closed
position
By pressingUP-button you can do corrections ofthe door position
6. Confirm the closed position by pressingSET
7. The operator now makes a force learning open and close cycle
8. After successfully achieved learning cycle the display showsu
In case the display shows „E" you must disconnet the operator for at least 10 seconds
from the power supply and re-do the steps above. Please ensure that there are no
obstacles in the doorway
.
Pairing transmitter
Press„CODE"-buttonuntil the small LED-dot on the lower right corner switches on.
Now press the button oft he transmitter that you want to programm.
The LED-dot switches off. Now press the same button on the transmitter again and the
LED-dot flashes fast and the display shows „u".
The transmitter is paired.
For additional transmitters (max.20 pcs.) re-do the steps above.
For deletingall transmitters press and keep CODE-button pressed for at least 10 seconds
until the display shows„C". All transmitters are deleted.
9