Cleaning/ Maintenance Instructions - KEKAI Swing Black Manual De Instrucciones

- WARNING: In order to avoid overheating, do
not cover the heater.
- The heater must not be located immediately below a socket-outlet.
- Means for disconnection having a contact separation in all poles must
be incorporated in the fixed wiring in accordance with the wiring rules.
- The heater must be installed at least 1.8 m above the floor.
- Means for disconnection having a contact separation in all poles must
be incorporated in the fixed wiring in accordance with the wiring rules.
- Do not use this heater in the immediate surroundings of a bath,a shower
or swimming pool.

CLEANING/ MAINTENANCE INSTRUCTIONS:

During Season Care:
Before cleaning, be sure to turn off and unplug the heater.
●
Carefully wipe the unit with a soft, damp cloth. Please be very cautious near the motor and
●
heating elements.
Do not immerse the heater in water.
●
Never use gasoline, benzene or thinner. This will damage the surface of the heater.
●
After cleaning, be sure to completely dry the unit with a cloth or towel.
●
After Season Care:
Store heater in a cool and dry location with power cord properly secured.
●
Please store the unit in its original carton or suitable container.
●
PRE—OPERATING INSTRUCTIONS:

Carefully remove your heater from the box (please save the carton for off-season storage)

Make sure the unit is in the OFF position before plugging the heater into the outlet.

Place heater on a firm level surface.
OPERATING INSTRUCTIONS:

Before inserting the plug into an electrical outlet, make sure that the electrical supply in your
area matches that on the rating label on the unit.

When plugged in, turn on the Main power switch at the back of the unit.

When in Standby mode, only the switch
and the LED display shows the room temperature. Press
panel or remote control
a) Low Power: 1000W (Press "
b) High Power: 2000W (Press "
c) TIMER: Press " " button repeatedly to set a period after which the heater will turn
itself off (From 0 hour – 8 hours)
d) + , - : adjust room temperature .Temperature setting from10-49 degree. "+" to increase
the desired temperature and "-" to decrease the desired temperature. (On Remote control
only)
The heater working on full power when the room temperature is 4°C lower than the
setting temperature.
The heater working on half power when the room temperature is between 0° and 2°C
lower than the setting temperature.
The heater switches off when the room temperature is higher than the setting
temperature. the fan working 30 seconds to make inside cool to protect component,
then fan stop, the unit enter into standby.
The heater switches on again when the room temperature falls 2°C below the setting
temperature.
e) Osc : Press " "to activate oscillation. Press it again to cancel.
f) Press to turn off the heater, the unit will keep working 30 seconds of cool air after turn
off it . this design can protect item use longer.
Warning: The heater will remain hot for some time after it is turned off; handle with care.
on the control panel will respond to your touch,
to access the rest of the control
" to switch it)
"to switch it)