Using The Heater - KEKAI Touch Screen Manual De Instrucciones

ASSEMBLY BASIS
Step1
Fixing the base
with screws

USING THE HEATER

1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label of the unit.
2. When plugged in, turn on the Main power switch
3. When in Standby mode, only press
the LED display shows the room temperature. Press
control panel.
(a) Low Power: 1300W (Press
(b) High Power: 2000W (Press
(c) TIMER: Press this button
itself off (From 0 hour -8 hours)
(d) + , - : adjust room temperature .Temperature setting from 10-49℃. Press "
increase the desired temperature and "
the room temperature lower 4 ℃ than the settled temperature of unit, it's high power
working, lower 2℃, lower power working, if room temperature reach the setting
temperature, the heating stop, fan is permanently on till room temperature lower than the
setting temperature 2℃, the unit automatically return to lower power heating, if room
temperature lower 4 ℃ , higher power heating, it's automatically return to heating.
(e) Swing : Press
(f) Press to turn off the heater, the unit will keep working 30 seconds of cool air after turn
off it . this design can protect item use longer.
Registration hole
on the control panel will respond to your touch, and
to switch it, one
to switch it, two
repeatedly to set a period after which the heater will turn
" to decrease the desired temperature. When
to activate swing. Press it again to cancel.
Fixing the base with screws
Pillar
at the back of the unit.
to access the rest of the
light on )
light on together )
Step2
" to