Advanced Settings; System Settings; Installation And Mounting - Cameo HYDRABEAM 1000 RGBW Manual De Usuario

ADVANCED SETTINGS

Press MENU to access the selection menu for system settings. Using the UP and DOWN controls, select the menu item "Advanced Settings"
(coloured background) and confirm with ENTER. This will take you to the submenu for setting the following submenu items (selection with
UP and DOWN, confirm with ENTER):

System Settings

Advanced Settings
Reset
DMX Address 001
DMX Mode CH-14 Pan Invert
Auto Mode Auto06 Tilt Invert
Slave Mode On Display
Advanced Settings Display Invert
DMX Fail
Software
Advanced Settings
Reset = Reset motors
Pan Invert = pan direction
Tilt Invert = tilt direction
Display = Display lighting
Display = Rotate display
Invert
DMX Fail = Operating status with DMX
signal fault
Software = displays device software

INSTALLATION AND MOUNTING

Thanks to its pre-installed rubber feet, the spotlight can be positioned in a suitable location on the stage floor etc. Mounting on a traverse
is achieved with the supplied Omega bracket (only use original accessories) and a suitable traverse clamp (not included). Secure the device
in the selected position with a suitable safety cable. To do this, attach the Omega bracket bolts to the base of the housing using a 5mm hex
tool and the two M6 hexagon bolts. Attach the supplied M6 securing lug to the left or right of the Omega bracket.
Important: Overhead mounting requires extensive experience, including the calculation of the load limit values of the installation material
and regular safety inspection of all installation materials and spotlights.
If you do not have these qualifications, do not attempt to perform an installation yourself. Refer instead to a qualified professional.
No/Yes
No/Yes
No/Yes
On/Off
No/Yes
Auto/Black/Hold
V1.x
Yes
No
No
Yes
No
Yes
On
Off
No
Yes
Auto
Black
Hold
V1.x
= reset the pan & tilt motors
= cancel reset of pan & tilt motors
= do not reverse pan direction
= reverse pan direction
= do not reverse tilt direction
= reverse tilt direction
= permanently on
Deactivation after approximately 1 minute of inactivity
= no display rotation
= rotate display by 180° (e.g. for overhead installation)
= activates Auto mode
= activates blackout
= last command is retained
7