Publicidad
Idiomas disponibles
Idiomas disponibles
FlyCamOne
2
External shutter release
In all video modes "VR", "VE", "VL", "SR", "SE", "SL" and in photo mode "PE" recording is running while pins 1 & 2 are connected and will stop when
disconnected.
In photo mode "PR" only one photo will be shot when pin 1 & 2 are connected. Connecting again will shoot the next photo.
The shutter speed will not be changed due to longer connection!
Software update
2
Update your FlyCamOne
with new software from the homepage.
Find drivers, firmware and manuals at service/support on www.FlyCamOne.com.
Assemling on a model aircraft/ model helicopter
Make sure, that the FCO² keeps a sure positon for precluding possible damages.
Make sure that the model gets enough uplift for carrying the FCO².
Fix the FCO² by the velcro-pad at the model aircraft. Let the FCO² snap and check the main emphasis again.
The installation at a model aircraft enables records down and from there 90° stepless towards the front. With a free analog resp. proportional channel at
your receiver the steering by a servo is possible. The triggering can take place by a free digital channel.
For some adaptations it´s necessary to install the camera headfirst (for example on the top of a r/c car). The record can be turned around 180° by using the
Microsoft® Movie Maker ™.
Safe the camera against losing by putting the supplied brace through the eyelet.
Vibrations will let the picture getting "wavy" – take care of a smoothly run of the engines, propellers and rotors!
Limited Warranty of Battery
The included Lipo battery's capacity is reduced due every discharge /charging circle and belongs to the wearing parts. Improper use storage and handling as well as
wearing and consumption is not covered by the warranty.
www.FlyCamOne.com
Publicidad
