Installation Instructions - Candy CDG31SPX Manual De Instrucciones

-
Aluminium film or papers are not suitable for this appliance;
-
Do not use acid, toxic or corrosive cleaners, for safety health. Just use a damp cloth and warm water;
Barbecue
Fig.18
To turn on the element, turn the knob clockwise; this sets the relative thermostat, with settings
from "1" to "10". The pilot light turns on to show that the element is in operation.
It is normal for some types of lamp to show a little light even when the plates are not working.
Using the grid : Before using the grid, it is always advisable to check that it is firmly positioned and
correctly placed on the hob. Also check that the rubber pads it rests on are intact and properly in place.
Lava rock : Place the rock inside the tray provided and dispose of the bag.
Once it is in place, turn on the heating element.
Fryer
Fig.20
To set the cooking temperature, turn the knob clockwise, up to a maximum setting of 200°C.
When the heating element comes on, two lights, one green and one red, light up.
The red light goes out when the selected temperature is reached.
It is normal for some types of lamp to show a little light even when the plates are not working.
Advice and warnings: Put the frying oil in the container provided before switching on the heating element.
After cooking, wait for the oil to cool before emptying the container. After cooking, turn knobs back to the
"0" setting. If the regulator thermostat fails, a thermostat with manual reset will be activated;
this must be reactivated by a skilled engineer.

INSTALLATION INSTRUCTIONS

Important!
-
These instructions are intended for qualified technicians.
-
The appliance must be installed correctly, in compliance with current laws.
-
Before carrying out any operation on the appliance, it must be disconnected from the electric supply.
Fitting the appliance in the worktop
The cooktop may be fitted into any worktop, as long as it is heat resistant (minimum temperature of 90°C)
The dimensions of the hole to be made in the worktop and the minimum distances between rear
and side walls and those above the appliance are shown in figure 4.
Isolation below (fig.6):
-
If the cooktop is installed without an oven below it, a separator panel must be placed between
the bottom of the cooktop and the housing below it, at a minimum distance of 10 mm.
-
If the cooktop is installed over an oven, place a separator panel at a minimum distance of 15mm
and follow the oven manufacturer's instructions, ensuring nonetheless sufficient aeration
as specified in fig.6.
In any event, the electrical connection of the two appliances must be carried out
separately, both for electrical safety and to facilitate removal.
It is advisable to use an oven equipped with an internal forced cooling system.
Fixing the cooktop (fig.7):
To fix the cooktop in the housing, proceed as follows:
-
Position the special gasket supplied [C] along the outer perimeter of the worktop, following the
diagram shown in fig.4, so that the ends of the gasket meet exactly without overlapping.
-
Position the cooktop into the worktop, taking care to ensure it is placed exactly in the centre.
-
Fix the cooktop to the worktop using the special brackets supplied [A], as shown in fig.7.
Correct installation of the sealing gasket ensures complete protection against infiltration of liquids.
Installation area and removal of combustion fumes
The appliance must be installed and operated in suitable areas, and in compliance with current laws.