Listado De Parámetros - Vega VEGAFLEX 83 Instrucciones De Servicio

General Information
Listado de parámetros
La tabla siguiente da un resumen sobre los parámetros utilizados.
FF desciptor
PRIMARY_VALUE
PRIMARY_VALUE_UNIT
SECONDARY_VALUE_1
SECONDARY_VALUE_1_
UNIT
SECONDARY_VALUE_2
FILL_HEIGHT_VALUE
FILL_HEIGHT_VALUE_UNIT
CONST_VALUE
SECONDARY_VALUE_1_
TYPE
SECONDARY_VALUE_2_
TYPE
FILL_HEIGHT_VALUE_Type
DIAGNOSIS
DIAG_MASK_1
DIAG_OUT_1
DIAG_MASK_2
DIAG_OUT_2
DEVICE_IDENTIFICATION
DEVICE_NAME
IS-SPARE_ELECTRONICS
DEVICE_VERSION_INFO
CALIBRATION_DATE
FIRMWARE_VERSION_ASCII Software version
HW_VERSION_ASCII
VEGAFLEX 83 • Foundation Fieldbus
LAS (Link Active Scheduler)
Master Capable
Number of VCRs (Virtual Communication Re-
lationships)
Description
PRIMARY_VALUE (Linearized value). This is the process va-
lue after min/max adjustment and Linearization with the status
of the transducer block. The unit is defined in "PRIMARY_VA-
LUE_UNIT"
Selected unit code for "PRIMARY_VALUE"
This is the measured value after min/max adjustment with the
status of the transducer block. The unit is defined in "SECON-
DARY_VALUE_1_UNIT"
Selected unit code for "SECONDARY_VALUE_1"
This is the distance value ("sensor_value") with the status of
the transducer block. The unit is defined in "SECONDARY_VA-
LUE_2_UNIT"
Filling height. The unit is defined in "FILL_HEIGHT_VALUE_
UNIT"
Filling height unit
Constant value
Secondary value 1 type
Secondary value 2 type
Filling height value type
AITB Diagnosis
Manufacturer ID, device type, bus type ID, measurement princi-
ple, serial number, DTM ID, device revision
Device name
Device name
Hard- and software version for system, function and error
Day, month and year
Hardware version
11 Anexo
Yes
Yes
24
Unit
75