Power Dynamics PDE-15A Manual De Instrucciones página 8

TROUBLESHOOTING
One certain method of determining if a speaker is faulty is to substitute a speaker
that is known to work correctly for the suspected problem speaker. If the "normally
correct speaker" is experiencing the same difficulties or problems as the suspected
problem speaker, use the information below to isolate the problem.
No output
Possible cause
Speaker cables
Intermittent
Possible cause
Poor connections
Constant noise, buzzing and/or humming
Possible cause
Faulty electronic
SPECIFICATIONS
Item
Output power
Output power (music)
Sensitivity
Frequency Range
Input(s)
Woofer (inch)
Dimensions
Weight
Ref. Nr.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit.
This would also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by
inappropriate use or disrespect of the warnings contained in this manual. Tronios cannot be held responsible for
personal injuries caused by a disrespect of the safety recommendations and warnings. This is also applicable to all
damages in whatever form.
Action
Reseat all connectors
Inspect cable for damage
Inspect wire or connector for stray strand that may short
Action
While it is possible for a faulty speaker to exhibit
intermittent output, it's more likely that an output
cable/connector is the problem. Reseat all connectors
Action
Any constant noise originates in the amplifier, mixer,
signal processing, source device in the signal devices, or
line-level wiring. Check and correct system grounding as
required. Chain check for noisy sources or electronic
components. Check wiring for shielding.
PDE-12A USB/SD/MP3
250W
500W
123dB
50-18.000Hz
1x Line + 2x Mic + USB +
SD card
12"
575 x 365 x 290 mm
14kg
178.880
PDE-15A USB/SD/MP3
300W
600W
126dB
40-18.000Hz
1x Line + 2x Mic + USB +
SD card
15"
700 x 450 x 345 mm
20kg
178.883
8 - 16