Reloop TURN2 Manual De Instrucciones página 10

SETTING UP & CONNECTIONS
1. Mount the Platter -1- onto the motor. To do so, place the Platter above the Turntable Hub -3-.
2. Pull the belt -4- to the lower side of the Turntable over the Drive Hub -2-.
3. Place the supplied felt mat above the Turntable Hub -3- and onto the Turntable.
4. Place the Counterweight -13- onto the Tonearm -8-.
NOTE! The Counterweight Scale -12- has to face forward.
5. Screw the Headshell with Pick-Up System -7- into the Tonearm -8-. The pick-up system is easy to exchange, if required:
a) First loosen the fastening screw on the headshell and disconnect the cable of the supplied pick-up system.
b) Remove the old pick-up system from the headshell.
c) Now connect the leads of the pick-up system and observe the assignment of wires:
Colour
I. White (L+)
II. Blue (L-)
III. Red (R+)
IV. Green (R-)
d) Tighten the fastening screws on the headshell.
6. Connect the included RCA cable to the Audio Output -14- / -15- and connect the cable to a phono input of your amplifier or HiFi sound system.
7. Connect the Power Supply Unit to its appropriate connection -18- and a power outlet.
OPERATION
1. Counterweight
Bring the Tonearm Lift -10- to the „DOWN" position. Guide the Tonearm -8- just in front of the Turntable -1-. Adjust the Counterweight -13- by
turning it clockwise as such that the Tonearm -8- does not lean up nor down, i.e. it should be balanced parallel to the record. Then return the
Tonearm -8- to its support -9-. Set the Counterweight Scale -12- as such that the „0" position is above the marked line. Continue turning the
counterweight clockwise until the scale indicates the value which corresponds to the recommended stylus force of the pick-up system.
2. Anti-Skating Wheel
Adjust the Anti-Skating Wheel -11- as such that the value of the stylus force corresponds to the stylus force of the pick-up system.
3. Turning on Power
After all connections have been made and all settings have been adjusted you can turn the device on via the ON/OFF Button -5-.
4. Playback
Place the record on the felt mat that is placed on the record platter -1-. Select the correct speed for your record via the 33/45 Switch -6-. Re-
move the headshell from the Pick-Up System -7-. Now bring the Tonearm Lift -10- into the "UP" position and move the Tonearm -8- just above
the desired position of the record. Then bring the Tonearm Lift -10- "Down" so that the Tonearm -8- lowers into the vinyl groove.
NOTE! It is possible to leave the Tonearm Lift permanently in a "Down" position and to lower the Tonearm manually onto the desired po-
sition. When doing so, be sure not to damage the stylus of the Pick-Up System.
5. Dust Cover
The Dust Cover protects your turntable and allows safekeeping. However, we recommend to remove the Dust Cover during playback of records
as it may have a negative inpact on the acoustic pattern. Moreover, your turntable should be placed on a resonance-free base, such as a mul-
tiplex or wooden panel.
10
Polarity
Left, Positive Pole
Left, Negative Pole
Right, Positive Pole
Right, Negative Pole