Features - Urrea SURTEK CM714A Manual De Usuario

• NEVER LEAVE THE CUT-OFF SAW RUNNING
UNATTENDED. WHEN FINISHED WITH A CUT-
TING OPERATION, TURN "OFF" THE CUT-OFF
SAW AND WAIT UNTIL IT COMES TO A COM-
PLETE STOP.
• SECURE THE ELECTRICAL POWER CORD
WHEN THE CUT-OFF SAW IS NOT IN USE to
prevent unauthorized use of the tool and/or
to prevent children from accidentally turning
it on.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. ON/OFF SWITCH.
2. CUTTING WHEEL.
3. WHEEL COVER.
4. VISE.
5. CLAMP SCREW
HANDLE.
6. STOPPER.
7. BASE.
8. CARBON
5
BRUSHES.
BEFORE OPERATION
1. Make sure the power source is appropriate
for the tool.
WARNING: Never connect the power tool
unless the available AC power source is of the
same voltage as that specified on the name-
plate of the tool.
2. Make sure the trigger switch is turned OFF.
WARNING: If the power cord is connected
to the power source with the trigger switch
turned ON, the power tool will start suddenly
and could cause a serious accident.
3. Check the cut-off wheel for visible defects.
Confirm that the cut-off wheel is free of cracks
or other visible damages.
4. Confirm that the cut-off wheel is fixed se-
curely to the power tool. Using the supplied
hex. bar wrench, tighten the clamping bolt on
14
1
8
2
4
7
the cut-off wheel mounting shaft to secure the
cut-off wheel.
WARNING: When the clamping bolt is
loose, the cut-off wheel may be damaged
when the wheel axle starts revolving, causing
a hazardous condition.
5. Use cut-off wheels whose peripheral speed
ratings are over the maximum working periph-
eral speed. When replacing the cut-off wheel,
ensure that the replacement cut-off wheel has
a designed peripheral speed.
6. Confirm the stopper position. Confirm that
the stopper which was used for installtion and
removal of the cut-off wheel has returned to
the retract position.
7. Securely fix the cutting material. Ensure that
the material is securely fastened with the vise.
If it is not, a serious accident could be caused if
3
the material comes loose or the cut-off wheel
breaks during operation.
8. Check the Power Receptacle. To prevent
overheating or accidental stopping, confirm
that the power plug fits properly in the elec-
trical receptacle and does not fall out after it
is inserted. Repair or replace the receptacle, if
it is faulty.
9. Confirm that the tool's power cable is not
damaged. Repair or replace the power cord
if an inspection of the cabtire cable indicates
that it is damaged.
AFTER CONNECTING THE POWER PLUG TO AN
APPROPRIATE AC POWER SOURCE, CHECK THE
OPERATION OF THE TOOL, AS FOLLOWS:
• Trial Run. After confirming that no one is
standing in front of it, step away from the
front position and start the power tool and
confirm that no operating abnormalities exist
before attempting a cutting operation. Trial
run periods:
When replacing the cut-off wheel;
Over 3 minutes.
When starting routine work;
Over 1 minute.
• Inspect the rotating stability of the cut-off
wheel. For precise cutting, rotate the cut-off
wheel and check for deflection to confirm that
the wheel is not noticeably unstable; otherwise
vibration might occur and cause an accident.