Maintenance; Parts List - Sagola HT10 Manual De Instrucciones

It is considered that the unit and its accessories are
totally clean when the product sprayed through the
gun, and that circulating through the product return
probe (Fig.1 nº2), is clean thinner and free from the
product previously applied, meaning that the process
must be repeated as many times as necessary.
Once the unit and its accessories are clean, and as a
prior step before definitively stopping it, the Depressu-
risation procedure described before in Section 10 of
the Manual must be applied.
Clean the Suction Probe filters or the product cup, antipul-
se and those of the spray gun.
Remove any remains of product from the gun, hoses and
the rest of the unit with a cloth soaked in thinner.
Keep gasket areas free of accretions and foreign bodies.
The air cap is a precision component. Any deformation,
especially in the product outlet orifices, may cause
malfunctions in its operation and incorrect or deficient
quality spraying.
If necessary, dip the air cap in thinner in order to soften the
remains of product or dirt. Once softened, blow the cap
Before starting to work, verify the state of the product
hoses and the connections of the elements through which
the product flows.
In order to carry out maintenance or repairs, first discon-
nect the unit from the compressed air distribution network.
Never move the unit by tugging on the hoses.
Always place the unit at a distance of least 6 metres away
from where the product is to be applied.
Do not apply excessive force or inadequate tools for main-
taining and cleaning the unit. Some repairs must be done
page 9
with compressed air until any remains of product and
thinner are eliminated.
For automatic cleaning of the gun, tools and accessories
used in the mixing and preparation of the product to be
applied, we recommend the use of SAGOLA Washing
Machines.
IMPORTANT
The gun can be cleaned with thinners or detergents in
a gun washing machine.
If you opt for this cleaning system, we advise you to
remember the following considerations, which, if not
applied, may damage the gun and render the warranty null
and void.
1- Do not submerge the gun in solvent or detergents longer
than the time required for cleaning.
2- Do not use the gun immediately after cleaning has been
completed.
3- Ensure that there is no thinner or detergent inside and
that it is completely free of these. Other cleaning systems
can be used (ultrasound).

14. MAINTENANCE

with special tools on some occasions. In these cases, you
must contact the Customer Service of SAGOLA. Any
handling of this product by non-authorised personnel would
render the warranty null and void.
The unit must be overhauled on a periodic basis to check
the status of its components and replace these when they
are not in perfect condition.
IN
RESULTS, ALWAYS USE ORIGINAL SAGOLA SPARES
THAT GUARANTEE TOTAL INTERCHANGEABILITY,
SAFETY AND PERFECT OPERATION.

15. PARTS LIST

53
43
41 42
40
38
39
44
52
50
49
46
45
51
47
48
54
39
56
57
58
page 10
- 20 -
ORDER TO OBTAIN
59
61
60
1 HT10
2 HT15
3 HT25
71
69
92 39
77
76
79
78
73 76
74
75
HT
page 11
THE BEST POSSIBLE
1 HT10/15 1 HT10/15
2 HT25 2 HT25
92
65
66
67
93
64
68
1 HT10/15
94
06 2 HT25
39
63
1 HT10/15
95
2 HT25
1 HT10
2 HT15
3 HT25
1 HT10
2 HT15
72
3 HT25
70
HT
HT
81 83
80
82
82
84
85 86
87
88
90
91
89