Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
35 Maximum pressure
36 Volume of pressure vessel
37 Waste disposal symbol – Machine
can be disposed of by returning it
to the manufacturer
3.4
Safety Devices
Safety valve
40
The spring-loaded safety valve (40) can
be found on the ON/OFF switch. The
safety valve opens if the max. permissi-
ble pressure is exceeded.
4.
Operation
4.1
Prior to initial operation
Insert dip stick
1. Remove the plug (42) from the
crankcase.
41
42
2. Substitute the plug (41) with the dip
stick supplied.
The plug prevents oil from leaking from
the crankcase during shipping. Keep
plug for future use.
Assembling the air filter
1. Remove the plug from the air inlet
of the compressor pump housing.
Keep plug for future use.
2. Screw the enclosed air filter (44)
onto the air inlet (43).
3. Proceed in the same way for the
second filter.
Checking the condensate outlet
•
Make sure that the outlet screw (45)
of the condensate outlet is closed.
45
4.2
Mains connection
B
Danger! High voltage
Operate machine in dry environment
only. Operate machine only on a power
source complying with the following re-
quirements:
– outlets properly installed, earthed
and tested;
– fuse protection in accordance with
the technical specifications.
Make sure that the mains cable is out
of the way so that it does not interfere
with the work and cannot be damaged.
Always check to see that the machine
is switched OFF before plugging in.
Protect mains cable from heat, aggres-
sive liquids and sharp edges.
Use only extension cables with suffi-
cient lead cross section (see "Technical
Specifications").
Do not stop the compressor by unplug-
ging, but switch OFF using the switch.
Unplug after use.
4.3
Generating compressed
air
1. Start compressor (47) and wait until
the max. tank pressure is reached
(compressor shuts off). The tank
pressure is indicated by the tank
pressure gauge (48).
43
46
44
50
2. Set pressure regulator (49) to re-
quired working pressure. The cur-
rent working pressure is indicated
by the regulated pressure gauge
(46).
A
Caution!
The regulated pressure may not be set
higher than the max. working pressure
of the connected air tools!
3. Connect air hose to compressed air
outlet (50).
4. Connect air tool. You are now ready
to work with the air tool.
5. Switch the compressor OFF (47), if
you do not continue working imme-
diately afterwards. Unplug after
switching OFF.
6. Drain condensation water from
pressure vessel once a day (51).
ENGLISH
47
49
48
51
13
Publicidad
Capítulos
Tabla de contenido
