Operation; Stand Alone Operation; Call Up The Internal Program; Master/Slave-Operation - EuroLite TS-150 Manual Del Usuario

The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the TS-150 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the TS-150 can be used without controller. You can do without a controller as the
TS-150 features a built-in microphone, which provides automatic sound control.
Disconnect the TS-150 from the controller and set all DIP-switches to Off.
The lamp is automatically ignited as soon as the condensor microphone receives music signals.

Call up the internal program

In order to call up the internal program, set DIP-switches No. 9 and 10 to On.

Master/Slave-operation

Connect the master and slave-devices as desribed above and set the DIP-switches accordingly.
Please note: If you wish to change from one operating mode into another, you either have to switch off the
lamp/activate Blackout-mode or unplug the projector from the mains and plug it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

DMX-protocol

Control channel 1 - Horizontal movement (Pan) (within 180°)
Push slider up in order to move the mirror horizontally (PAN).
Gradual mirror adjustment from one end of the slider to the other (0-255, 128-center). The mirror can be
stopped at any position you wish.
DMX-value Feature
0-255 Gradual adjustment of the mirror position from left to right
Control channel 2 - Vertical movement (Tilt) (within 90°)
Push slider up in order to move the mirror vertically (TILT).
Gradual mirror adjustment from one end of the slider to the other (0-255, 128-center). The mirror can be
stopped at any position you wish.
DMX-value Feature
0-255 Gradual adjustment of the mirror position from down to up
International
L
N
25