Power Supply - Beamz FLATPAR 36X 1W RGB Manual De Instrucciones

INSTALLATION
Attention:

The installation of the fixture has to be built and constructed in a way that it can hold 10 times the weight for 1
hour without any harming deformation.

The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This
secondary safety attachment must be constructed in a way that no part of the installation can fall down if the
main attachment fails.

Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and
servicing.

The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another time.

The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.

The fixture should be installed in the position where persons cannot reach and where persons may walk by or
be seated.
CAUTION: When installing the device, make sure there is no highly
POWERSUPPLY
On the label on the backside of the light effect is indicated on this type of power supply must be connected. Check
that the mains voltage corresponds to this, all other voltages than specified, the light effect can be irreparably
damaged. The light effect must also be directly connected to the mains and may be used. No dimmer or adjustable

power supply.

CAUTION: Please consider the respective national norms during the
installation! The installation must only be carried out by
an authorized employee or dealers!
in inflammable material (decoration articles, etc.) in
between a distance of min o.5 meter.
ENGLISH