BLACK&DECKER CS2000 Manual De Instrucciones página 21

g. If devices are provided for the connection of dust extraction and collection facilities, ensure
these are connected and properly used. Use of dust collection can reduce dust-related hazards.
4. Power tool use and care
a. Do not force the power tool. Use the correct power tool for your application. The correct power
tool will do the job better and safer at the rate for which it was designed.
b. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be
controlled with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source and/or the battery pack from the power tool before
making any adjustments, changing accessories, or storing power tools. Such preventive safety
measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the
power tool or these instructions to operate the power tool. Power tools are dangerous in the hands
of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may affect the power tools operation. If damaged, have the power
tool repaired before use. Many accidents are caused by poorly maintained power tools.
f. Use the power tool, accessories and tool bits etc., in accordance with these instructions, taking
into account the working conditions and the work to be performed. Use of the power tool for
operations different from those intended could result in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
6. Electrical Safety
Your tool is double insulated; therefore no earth wire is required. Always check that the main
voltage corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must be replaced by the manufacturer, authorized
Black & Decker Service Center or an equally qualified person in order to avoid damage or injury.
If the power cord is replaced by an equally qualified person, but not authorized by
Black & Decker, the warranty will not be valid.
7. Labels on Tool
The label on your tool may include the following symbols:
Read Instruction Manual
Use Eye Protection
Use Ear Protection
V...............................Volts
A.............................. Amperes
Hz............................ Hertz
W..............................Watts
min...........................minutes
...........................Alternating current
...........................Direct current
n ............................. No load speed
0
...........................Class II Construction
...........................Earthing terminal
...........................Safety alert symbol
.../min...................... Revolutions or reciprocations
per minute
21
ENGLISH