Parameter Adjustment - ELRO EQUAJET Manual De Instalación

3E-490043NI – 03/20
FREQUENCY OF MAINTENANCE AND LEVEL OF USE PER DAY
- Press the « Cleaning/Tool » button
- Scroll through the parameters until you get to installation: « inSt » using the coder of the
- Select the « inSt » parameter button
- Enter the PIN code for the installer « inSb »:
* The first digit appears in cyan and flashes. Using the coder or the
* Once the value is correct pressing the coder or the « PROG/VALID » button moves you on to the next digit which can be altered in the same way
* When all the code has been entered and it is correct access the menu or start on the PIN number again.
- Enter the number of hours before the next service visit (1500 hours by default): « HSr ». Adjustable from 100 to 5000 hours. Allow at least one
service per year.
* Select the value to be modified
* Adjust the setting using the coder or the
* Once adjusted press the coder or the "PROG/VALID" button allows you to pass to the next parameter.
- Enter the average hours per day that the unit is likely to operate for: « H-d ». Adjustable from 1 to 24 hours.
* Select the value to be modified
* Adjust the value using the coder or the
* Once adjusted pressing the coder or the "PROG/VALID" button allows you to pass to the next parameter.
WATER TREATMENT CAPACITY
This only functions if there are 2 separate supplies to the oven.
- Press the "Cleaning/Tool" button
- Scroll through the parameters until Client parameters: « CHEF » using the coder or the
- Select the « CHEF » parameter button
- Enter the PIN code for the client « CHEF »:
* The first digit appears in cyan and flashes. Using the coder or the
* Once the value is correct press the coder or the « PROG/VALID » button moves you on to the next digit which can be altered in the same way
* When all the code has been entered and it is correct access the menu or start on the PIN number again.
- Scroll through the parameters until the « H2o CAPA » menu, using the coder or the
- Select « H2o » to access the water treatment counter sub menu
- Modify or check the water treatment capacity (in litres). Set to zero by default (if there is not a dedicated water treatment system for the oven).
* Select the value to be modified
* Adjust using the coder or the

PARAMETER ADJUSTMENT

/ buttons.
/ buttons.
/ buttons.
Page 1
/ buttons.
/ buttons allows you to change the value of the first digit.
/ buttons.
/ buttons allows you to change the value of the first digit.
/ buttons.
EN
ELRO-Werke AG
Wohlerstrasse 47
5620 Bremgarten