PRESIDENT TEDDY Manual Del Usuario página 32

3) CHANNEL SELECTOR ~ BEEP
CHANNEL SELECTOR:  and  on front panel
These buttons allow increasing or decreasing a channel. A «beep» sounds each time
the channel changes if the BEEP function is activated.
BEEP
Beep on changing the channel, buttons etc.
Beep function enable : turn on the power while pressing the  (up) button.
Beep function disable : turn on the power while pressing the  (down) button.
4) CH9/19 ~ F
CH9/19 BUTTON
Channels 9 and 19 are automatically selected by pressing this button. A push activates
channel 9. A second push activates channel 19. A new push returns to the previous
configuration.
F - FREQUENCY BAND SELECTION
(configuration: EU ; PL ; d ; EC ; U).
The frequency bands have to be chosen according to the country of use. Don't use
any other configuration. Some countries need a user's licence.
See table page 50.
Proceeding: switch off the transceiver. Keep the key F pressed and switch on again.
and the letter corresponding to the configuration are blinking.
- In order to change the configuration, use the  and  keys on front panel.
- When the configuration is selected, press 1 second on the F key.
corresponding to the configuration are continuously displayed, a beep sounds. At
this point, confirm the selection by switching off the transceiver and then switching
it on again. See the configurations / frequency bands table at page 47 to 49.
5) DISPLAY
It shows all functions:
The BARGRAPH shows the reception level and the output power level.
6) AM / FM
This switch allows to select the modulation mode AM or FM.
Your modulation mode must correspond with the one of the person you are speaking
to.
AM/ Amplitude Modulation (AM) is for communications in areas where there are
obstacles and over medium distances.
FM/ Frequency Modulation (FM) is for nearby communications in flat, open areas.
AM/FM
2 function (only in U configuration)
nd
Allows to alternate the frequency bands CEPT and ENG in the U configuration. When
the ENG frequency band is selected, «UK» is displayed.
7) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the setting of
the equipment into the dashboard easier.
and the letter See cabling diagram page 49.
32