Urmet 1092/274H Manual De Usuario página 20

OPERATING FEATURES
PUSH BUTTON TO ACCESS
TO THE MENU ALONG THE
CAMERA CABLE
TO SELECT THE VIDEO OUTPUT
The 1092/274H camera may use 3 different video outputs, which are on the same BNC connector:

High-definition 1080P AHD (Analog High Definition) video output

CVBS standard interlaced video output

Video output in COMET mode
If pressing the menu access button to the RIGHT for a few seconds, you can select the AHD video output.
If pressing it for a few seconds to the LEFT, you can select the CVBS video output.
PAL e NTSC standards can be selected, besides from the OSD menu and for all video outputs, pressing
the menu access button to DOWN for a few seconds. The command works in toggle, selecting
alternatively PAL and NTSC.Pressing the button to UP it is also possible to select the video output to
720P (with reduction of the angle view).
You can enter the COMET video mode if you select an OSD menu item and if the video signal is in CVBS
(ADJUST menu).
NOTE: COMET option is available only with the CVBS video output.
The presence or absence of this option therefore permits to identify if the camera is using the CVBS or
AHD video output.
ATTENTION: in case of missing video on the connected device (monitor or DVR), check that the
video output is not set to NTSC or 1080P when you are using a DVR with 720P video inputs
In case of missing images in a DVR with AHD and CVBS inputs, try the following steps:
1. Leave a single camera connected to the channel 1 of the DVR
2. Press the button for few seconds to right and left until the image appears on the
screen
3. If case of missing image again, press the button to down verify the type of input
selected on the DVR menu
20
UP
LEFT SET
DOWN
RIGHT
DS1092-219A