4..11 Single Shot And Continuous Scanning Modes - AEMC Instruments CA7026 Manual De Instrucciones

4..11 Single Shot and Continuous Scanning Modes

When the Fault Mapper Pro
mode.
In this mode, the Fault Mapper Pro
test when either the and buttons or the
Single Shot Mode: Saves on battery life and also enables
the Fault Mapper Pro
while still leaving the fault display on the screen.
To enter "Continuous Scanning" mode press and hold down the
button.
The icon will appear at the top of the display, when Continuous Scan-
ning mode is active.
Continuous Scanning Mode: fires pulses into the cable
under test at the rate of 6.7 pulses per second. In this
mode the Fault Mapper Pro
intermittent cable faults.
1
is first switched on, it is set to "Single Shot"
®
only fires a pulse into the cable under
®
to be disconnected from the cable
®
is able to more easily identify
®
button is pressed.
TEST /
Fault Mapper Pro
TEST /
® Model CA7026