Rockford Fosgate RFX Serie Instalación Y Funcionamiento página 22

T
ROUBLESHOOTING
S
YMPTOM
Engine Noise
CD Changer Troubleshooting
Error 1
(Initialize Error)
Error 2
(Magazine Eject
Error)
Error 3
(Loading Error)
Error 4
(Unloading Error)
22
D
IAGNOSIS
Source unit is not grounded
properly
Noise is radiating into RCA
signal cable
Bad component in the signal
chain
Noise is radiating into the
speaker cables
Multiple grounds in the audio
system
Disc unit can't detect magazine
Magazine tray load/unload
problem
Magazine sensor is defective
Can't eject magazine
Magazine emitting spring is
damaged
Magazine tray is jammed
Tray loading has not completed
after 5 seconds
Loading mechanism and motor
(or driving circuit) is defective
Tray unloading has not
completed after 5 seconds
Unloading mechanism and
motor (or driving circuit) is
defective
R
EMEDY
Check connections and repair wiring as
necessary
Check connections, run the RCA cables on a
route away from sources of high current
Check connections. Bypass all components
between the Source unit and the amplifier.
Connect one component at a time to
determine the culprit. Repair or replace
components as necessary
Disconnect speakers and connect a test
speaker to the output terminals or the source
unit. If noise is gone, reroute the speaker
cables away from sources of high current
Check ground connections and connect
amplifiers, signal processors, and other
components to a central location or try a
different grounding point on the chassis
Press the eject button and pull out the
magazine. Press the reset button
Check tray load/unload area
Have a service center check the magazine
sensing switch
Press the reset button
Have a service center inspect and repair as
necessary
Inspect and repair as necessary
Press Eject, pull out the magazine, and try
again. Press Reset
Repair mechanism and loading motor (or
driving circuit)
Press Eject, pullout the magazine, and try
again. Press Reset
Have a service center repair mechanism and
loading motor (or driving circuit)