Kärcher Windsor Priza Manual Del Usuario página 7

Overview
Quick start instructions
Illustration
1 Connect spray/suction hose to the el-
bow,
Connect spray/suction hose to the ap-
pliance
2 Prepare cleaning solution,
Fill up the fresh water tank
3 Select operating mode
4 Cleaning
5 Empty the fresh water tank
6 Empty wastewater container
7 Fill fresh water tank (without detergent),
Flush appliance
8 Clean lint trap,
Clean fresh water sieve
9 Allow appliance to dry
Device elements
Illustration
1 Manual nozzle for upholstery cleaning
2 Cable hook
3 Adapter for accessories (homebase)
4 Holder for accessories
5 Power cord
6 Quick start instructions
7 Fresh water tank
8 Fresh water sieve
9 Switch for spraying
10 Switch for vacuuming
11 Casing
12 Nameplate
13 Steering roller
14 Spray hose connection
15 Suction hose connection
16 Cover
17 Carrying handle of the appliance
18 Spray nozzle
19 Floor nozzle for carpet cleaning
20 Suction pipe
21 Handle
22 Bender
23 Lever on the manifold
24 Spray hose
25 Suction hose
26 Spray/suction hose
27 Dirt water reservoir, detachable
28 Carrying handle of the wastewater con-
tainer
29 Seal on the lid
30 Fluff filter
 Check high power cable, extension ca-
bles and hoses for damage every time
before use.
Attaching the Accessories
 Attach the suction pipe to the floor noz-
zle and hand-tighten the union nut on
the floor nozzle.
 If needed, slide handle onto suction
pipe and attach in the desired position
using the enclosed hexagon socket
wrench.
 Place the elbow over the suction pipe
and tighten the union joint on the elbow
fingertight.
 Insert the suction hose into the suction
hose connection on the appliance.
Attach the coupling of the spray hose to
the spray hose connection of the appli-
ance and snap in place.
 Connect the suction hose to the elbow.
Connect the coupling of the spray hose
with the manifold and snap in place.
Note: The manual nozzle for upholstery
cleaning is attached directly to the suction
hose without the use of the handle.
Prepare cleaning solution
WARNING
Health risk, risk of damage. Observe all in-
dications on the detergent used.
 Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
Dissolve detergent in the water.
Note: Warm water (max. 122°F/50°C) will
increase the cleaning effect. Verify the tem-
perature resistance of the surface to be
cleaned.
Note: For considerate treatment of the en-
vironment use detergent economically.
– 2
EN
Start up
7