Munchkin Auto Close MK0006-022 Manual Del Usuario página 4

How To Install Getting Started
STEP 1: IDENTIFY GATE PLACEMENT
For maximum security, DO NOT use this gate in any location without installing all 4 wall
cups, sticky pads and screws provided. In some openings only 2 top wall cups can be
fitted. The gate must be installed between two structurally sound surfaces.
GATE IS SUITABLE FOR:
TOP OF STAIRS
If installing the gate at the top of stairs, it MUST be
placed on the top landing and only swing away from
the stairs.
BOTTOM OF STAIRS
If installing the gate at the bottom of stairs, we
recommend placing it on the floor. If the gate must
be placed on the lowest stair, position it toward the
front of the step.
HALLWAYS AND DOORWAYS
Be sure that the gate is resting on the floor. The gate
should NOT be raised above the floor.
6
STEP 2: VERIFY PROPER WIDTH
Measure the width of the opening where the gate will be installed. Be sure to measure
at the narrowest point between the walls. For example, include any baseboards in your
measurement. Then, see below for the proper gate configuration for your opening.
TOOLS NEEDED:
Tape measure
35.4" - 37.8" (89.9 CM - 96CM)
Skip to page 9.
33" - 35" (83.8CM - 88.9CM)
Remove one 2.75" (7cm) small extension
(Proceed to page 8.)
29.5" - 32.5" (75CM - 82.5CM)
Remove two 2.75" (7cm) small extensions
(Proceed to page 8.)
PLEASE NOTE: See page 15 for additional
extension configurations.
How To Install
7