Troubleshooting Tips - GE GFWN1100 Manual Del Propietário

Before you call for service...

Troubleshooting Tips

Save time and money! Review the charts on the
following pages first and you may not need to call for
service.
Problem
Not draining
Not spinning
Not agitating
Leaking water
Clothes too wet
Possible Cause
Load is out of balance
Pump clogged
Drain hose is kinked or
improperly connected
Household drain may
be clogged
Drain hose siphoning; drain hose • Ensure there is an air gap between hose and drain.
pushed too far down the drain
Door gasket is damaged
Door gasket not damaged
Check back left of washer
for water
Fill hoses or drain hose is
improperly connected
Household drain may
be clogged
Dispenser clogged
Incorrect use of detergent
Dispenser box crack
Load is out of balance
Pump clogged
Overloading
Drain hose is kinked or
improperly connected
Household drain may
be clogged
Drain hose siphoning; drain hose • Ensure there is an air gap between hose and drain.
pushed too far down the drain
What To Do
• Redistribute clothes and run drain & spin or rinse & spin.
• Increase load size if washing small load containing heavy
and light items.
• See page 13 on how to clean the Pump Filter.
• Straighten drain hose and make sure washer is not
sitting on it.
• Check household plumbing. You may need to call
a plumber.
• Check to see if gasket is seated and not torn. Objects
left in pockets may cause damage to the washer (nails,
screws, pens, pencils).
• Water may drip from the door when the door is opened.
This is a normal operation.
• Carefully wipe off rubber door seal. Sometimes dirt or
clothing is left in this seal and can cause a small leak.
• If this area is wet, you have oversudsing condition.
Use less detergent.
• Make sure hose connections are tight at washer and
faucets and make sure end of drain hose is correctly
inserted in and secured to drain facility.
• Check household plumbing. You may need to call
a plumber.
• Powder soap may cause clogs inside the dispenser and
cause water to leak out the front of the dispenser. Remove
drawer and clean both drawer and inside of dispenser box.
Please refer to Cleaning the Washer section.
• Use HE and correct amount of detergent.
• If new installation, check for crack on inside of dispenser box.
• Redistribute clothes and run drain & spin or rinse & spin.
• Increase load size if washing small load containing heavy
and light items.
• The machine will slow the spin speed down to 410 rpm if
it has a hard time balancing the load. This speed is normal.
• See page 13 on how to clean the Pump Filter.
• The dry weight of the load should be less then 16 lb.
• Straighten drain hose and make sure washer is not
sitting on it.
• Check household plumbing. You may need to call
a plumber.
GEAppliances.com
21