Assembly; Unit Assembly - Solar PRO-LOGIX PL5100 Manual Del Propietário

Charger Assembly
1. Carefully remove the charger unit and all associated hardware from carton.
2. Attach handle to back of cabinet using (2) 1.25" bolts, threading bolts through handle holes and into holes
located on the rear of the charger.
3. Thread one M10x10 bolt into one end of the axle. Then, add one washer and one wheel to the axle,
pushing them down to meet the bolt. Push open end of axle through the holes in the side/bottom of
the charger case until the open axle end is expose on the other side of the case. Add second wheel
and washer to open axle end. Secure axle by threading remaining M10x10 bolt into open axle end (see
illustration).
4. Mount the front foot onto bottom of charger base using six (6) ST4.2x9 screws.
Case
Wheel
Washer
M10x10
Bolt

ASSEMBLY

Axle
9