Technical Data - EINHELL BT-SM 2534 Dual Manual De Instrucciones

4. Technical data

AC motor: ....................................... 230 V ~ 50Hz
Power: ....................2100 W S1 / 2350 W S6 25%
Idle speed n : ......................................4000 min
0
Carbide saw blade: ..............ø 250 x ø 30 x 3 mm
Number of teeth: ............................................. 48
Swiveling range: ............................ -45° / 0°/ +45°
Miter cut to the left: .................................0° to 45°
Miter cut to the right: ...............................0° to 45°
Saw width at 90°: ............................ 340 x 75 mm
Saw width at 45°: ............................ 240 x 75 mm
Saw width at 2 x 45°
(double miter cut left): ..................... 240 x 42 mm
Saw width at 2 x 45°
(double miter cut right): ................... 240 x 25 mm
Weight: ........................................... approx. 16 kg
Laser class: ....................................................... 2
Wavelength of laser: ................................ 650 nm
Laser output: ........................................... ≤ 1 mW
Operating mode S6 25%: Continuous operation
with idling (cycle time 10 minutes). To ensure that
the motor does not become excessively hot it
may only be operated for 25% of the cycle at the
specifi ed rating and must then be allowed to idle
for 75% of the cycle.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level ........................ 95 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ........................ 108 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 61029.
Vibration emission value a
K uncertainty = 1.5 m/s
2
Anl_BT_SM_2534_Dual_SPK7.indb 23 Anl_BT_SM_2534_Dual_SPK7.indb 23
GB
Warning!
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
-1
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
•
•
•
•
•
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
2. Damage to hearing if no suitable ear protec-
3. Health damage caused by hand-arm vib-
= 4.58 m/s
2
h
- 23 -
Only use appliances which are in perfect wor-
king order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever ne-
cessary.
Switch the appliance off when it is not in use.
mask is used.
tion is used.
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
09.05.12 11:29 09.05.12 11:29