Unpacking Instruction; Power Supply; Product Description - Fenton AV100BT Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

PRODUCT DESCRIPTION

1. Power ON/OFF
2. Microphone volume
3. Microphone echo adjustment
4. M-Tone
Microphone input 1 (6.3mm 1/4" jack)
5.
Microphone input 2 (6.3mm 1/4" jack)
6.
7. Bass adjustment
8. Treble adjustment
9. Balance adjustment
10. Input selection (AUX/USB/SD/BT)
11. VU-meter
12. Play/Pause / Previous / Next
13. Mode selection (USB/SD/BT)
14. USB input
15. SD input
16. Volume adjustment
17. Aux input (RCA)
18. Speaker Output Right/Left
19. Power lead
BT CONNECTION
1.
2.
3.
Attention: BT distance is approx. 10meter without any barrier.
Activate the BT on your device (Mobile phone, tablet etc.) which you want to play the music. See
the operating instructions for that device.
Press the "INPUT" button and activate BT on amplifier.
Select "GW-BT" on your BT device and pair.
3