Install The Unit - Multilaser Explorer Manual Del Usuario

3. Insert the battery holder into the remote controller.

14. INSTALL THE UNIT

DIN FRONT MOUNT
Manual do usuário . Manual del usuario
tab according to the thickness of the dashboard material and bend them
inwards to secure the holder in place.
Remove the unit
to remove the frame. (When reattaching the frame, point the side with a
groove downwards and attach it.)
of the unit as shown in figure until they click. Pulling the levers makes
possible to remove the unit from the dashboard.
DIN FRONT-MOUNT (method A)
1. Dashboard
2. Holder
After inserting the holder into the dashboard, select the appropriate
3. Screw
1. Dashboard
2. Nut (5mm)
3. Plan washer
4. Screw (5x25mm)
5. Screw
6. Strap
Be sure to use the strap to secure the back of the unit
in place. The strap can be bent by hand to the desired
angle.
7. Plain Washer
1. Frame
2. Insert fingers into the groove in the front of frame and pull out
3. Lever
Insert the levers supplied with the unit into the grooves at both sides
45