Status Indicator Lights
Selecting Cycles and Options
1. Select the desired cycle. If you want to run the last cycle that was completed, you can simply press START once to show which
options you used, then press START again to start the cycle.
Select the desired options. Not all options are available for every cycle. If an invalid option is selected for a given cycle, the
2.
lights will flash.
Turning OFF/ON the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound ON and OFF. The sound will not be deactivated for cycle interruption.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
To cancel selections and/or drain press and hold the START button for 3 seconds. If you drain the dishwasher by selecting CANCEL/
2.
DRAIN the word drain will turn on and the time display will show minutes of drain remaining. The drain will not begin until the door
is closed.
Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher
3.
drain completely. The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. See steps in the previous "Canceling A Cycle" section for canceling the current cycle.
Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before restarting
2.
your new cycle.
Select new cycles and options.
3.
Press START/RESUME.
4.
18
Dishwasher Feedback Section
The full lit display will glow for wash, drying, sanitized, and complete. It will also display the estimated
remaining time for the cycle in hours and minutes.
The indicator light (on some models) is green when running and off when the cycle is complete.
Canceling A Cycle
Changing A Cycle After Dishwasher Is Started