Temperature Display - Bresser MYTIME BATH Instrucciones De Uso

FEATURES
• Water resistant
• LCD display with indication of indoor temperature (° C)
• Easy to install with four strong suction cups
• Modern design with an elegant aluminum frame
START-UP/POWER SUPPLY
1. Turn the housing cover (9) with a little force, counter-clock-
wise and detach it.
2. Remove the locking pin from the clockwork. The clock can
be operated only after the pin has been removed.
3. Insert a 1.5V battery into the battery compartment (6) AA/
LR6. Pay attention to the correct polar direction (+ / - ) of the
battery as indicated inside the battery compartment.
RADIO CONTROLLED TIME
The radio controlled signal for time (DCF) is transmitted from
the central atomic clock in Frankfurt/Main in short intervals. It
has a reception range of approx. 1500 km.
• During night-time hours, atmospheric disturbances are typi-
cally less severe and radio signal reception may improve. A
single daily reception is sufficient enough to keep the clock
accuracy within 1 second.
• Make sure the unit is positioned at 8 feet (2 meters) distance
from any interference source such as a TV, computer mon-
itor, microwave, etc.
• Within concrete wall rooms such as basements or office
buildings, the received signal may be weakened.
8

TEMPERATURE DISPLAY

After inserting the battery, the interior temperature is displayed
on the LCD display (8). The temperature range is between 0°C
~ +50°C.
MOUNTING/POSITIONING OF THE CLOCK
There are 3 ways to mount this clock on the wall or on a flat
surface:
1. Open the housing cover (9) and remove the pedestal stand
(3). Insert it into the receptacle for the stand (7) and position
the clock on a flat surface (e.g. bathroom cabinet).
2. Hang the clock using a screw or nail (not included) onto the
desired and suitable wall (2).
3. Slightly moisten the suction cups (4) and press the clock
with the suction cups against a flat wall surface.
CAUTION:
Always make sure to mount or stand the clock securely.
Dropping the unit may cause serious damage, for which the
manufacturer takes no responsibility! The suction cups must
be placed on a perfectly flat, clean and dry surface. Moisture
favours slipping!
NOTES ON CLEANING
Before cleaning the device, disconnect it from the power sup-
ply (remove batteries).