Watts RD‑700 Instrucciones Para Instalar página 3

Adjust the roof drain to the height needed with the threaded rods included in the
hardware kit. Tighten the drain at desired height.
The ductile iron dome is impact resistant and finished with standard grey epoxy
coating.
Place the ductile iron dome over the drain body and align the holes for the screws
on both the flashing clamp and the dome.
Place the screws into the holes and tighten until snug.
Sump Receiver Installation Instructions
Place the sump receiver over the roof opening making sure that the recessed area
will accommodate the roof drain body while aligning with the leader pipe.
Lower the drain body into the opening and screw the deck flange into the sump
receiver and roof.
Position the roof dome over the drain and align the holes with the flashing clamp on
the drain body.
Place screws into the holes and tighten until dome fits snug against the drain body.