Klarstein 10032914 Manual De Uso página 35

Water Supply Hose
The appliance must be connected to the water mains using new hose-sets. The old hose-
sets should not be reused. Water pressure must be between 0,04 MPa and 1 MPa. If the
pressure is below the minimum consult our Service Department for advice.
• Connection: Pull The safety supply hoses completely out from storage com-
partment located at rear of dishwasher. Turn water fully on before starting the
dishwasher. Tighter the screws of the safety supply hose to the faucet with
thread 3/4inch.
• Disconnection: Turn off the water. Unscrew The safety supply 2 hose from the
faucet.
IMPORTANT: Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is
fastened tightly in place. If the water pipes are new or have not been used for an extended period of time, let
the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is
a risk that the water inlet can get blocked and damage the appliance.
Drain Hose
Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run into the sink, making sure
to avoid bending or crimping it. The top of the ho se must be less than 1000 mm. Use the special plastic support
that comes with the appliance. The free end of the hose must be at a height lower than 75 cm and must not be
immersed in water to avoid the back flow of it.
IMPORTANT: The special plastic hose support must be solidly fastened to the wall to prevent the drain hose
from moving and allowing water to spill outside the drain.
35