Velleman CM31011 Manual Del Usuario página 6

• It is important to broadcast the input signal on a free channel to avoid
distortion and noise. Change the channel by pressing the channel up [9] or
channel down [8] button. Refer to the table on page 3 of this manual for an
overview of the available channels and frequencies. Refer to your local cable
company for an overview chart to determine which channels are in use.
Look for 3 adjacent free channels and choose the middle one. If only 2
adjacent free channels are found, choose the higher one.
• Switch on the input device.
• Connect a TV-set to the in-house antenna network and switch to the set
channel on the RF modulator (refer to the manual of the TV-set).
• When the image appears distorted, choose a different channel on the
modulator and switch the TV to that new channel.
• When the sound appears distorted, turn down the volume on the input
device.
7. Technical Specification
RF standard
input connector
input frequency
output connector
output frequency
video input
video audio
included
power supply
dimensions
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulted from
(incorrect) use of this device.
For more info concerning this product, please visit our website
www.velleman.eu.
The information in this manual is subject to change without prior
notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman Components nv. All worldwide rights
reserved. This manual is copyrighted. No part of this manual may be copied, reproduced,
translated or reduced to any electronic medium or otherwise without the prior written consent of
the copyright holder.
04/02/2009
CAMRFM3
PAL B/G
IEC female, 75 Ohm
45~862MHz
IEC male, 75 Ohm
CH21-CH69 (UHF: 471.25~855.25MHz)
audio & video, RCA/SCART
audio & video, SCART (loop through)
1m male/female IEC cable
9VDC / 200mA (adaptor incl.)
120 x 80 x 26mm
6
®
Components nv
©Velleman