Replace The Blade; Store The Machine; Troubleshooting - GreenWorks Pro ULTRA POWER 60V LMC05 Manual Del Operador

EN
9.2

REPLACE THE BLADE

Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw (16) with a wrench or
socket.
7. Remove the blade (17).
8. Install the new blade. Make sure that the arrows engage
the holes in the blade.
9. Put in the mounting screw and tighten it.
9.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you put the machine
into storage.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
17
16
WARNING
WARNING
English
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
10

TROUBLESHOOTING

Problem
The handle is not
in position.
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
12
Possible cause Solution
The bolts are not Adjust the height
engaged correctly. of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery ca- Charge the battery
pacity is low. pack.
The bail switch is Replace the bail
defective. switch.
The battery key is Put in the battery
not put in. key.
The lawn is rough. Examine the mow-
ing area.
The blade height is Move the wheels
not set correctly. to a higher posi-
tion.
Wet grass clip- Wait until the
pings attach to the grass dries before
deck. mowing.
The mulch plug is Install the mulch
missing. plug.
The grass is too Increase the blade
tall, or the blade height.
height is too low.
The grass catcher Empty the grass
and the blade clippings from the
drags in thick grass catcher.
grass.