Power Switch - Stanton T.92 M2 USB Guia De Inicio Rapido

About Your Turntable
1) REVERSE - Used to reverse the direction of
the platter rotation.
2) START/STOP - Press this button to start or
stop the platter.
3) STROBE DOTS - The dots around the edge of
the platter are used in conjunction with the
light located inside the motor ON/OFF
switch. While the platter is in rotation, the
dots help to indicate the speed of rotation.
The speed is lower than the displayed speed
(33,45,78) when the dots are flowing to the
right. It is higher than the displayed speed
(33,45,78) when the dots are flowing to the
left. When the strobe is stopped, the platter
is rotating at the displayed speed.
4) STROBE LIGHT & MOTOR ON/OFF SWITCH -
As opposed to fully analog turntables, this is
not the power switch. This switch only turns
the motor on or off. Rotate clockwise to turn on the motor. The platter will not start spinning until the start/stop button
has been pressed. Rotate counterclockwise during playback (off position) for a slow winding down effect. The light
illuminates the strobe dots for setting speed.
5) PLATTER SPEED (rpm) - Select 33 or 45 rpm. For 78 rpm – Press the 33 and 45 buttons simultaneously. To return to 33 or
45 rpm play mode, just press the desired button.
6) HEADSHELL LOCKING NUT - Attach the headshell by inserting into the front end of the tone arm. Turn the locking nut
clockwise with the head shell firmly held horizontally.
7) KEY LOCK - Press to enable key lock. When KEY LOCK is on, the pitch slider will only affect the speed of the platter. The
key (pitch) will remain fixed. This speeds up the musical tempo without changing the pitch.
8) PITCH SLIDER and PITCH LOCK - The pitch slider is used to speed up or slow down the turntable platter to match tempos
with your other turntable while DJ'ing. When the Pitch Lock indicator is illuminated the speed of the platter is locked in
either 33 1/3, 45, or 78RPM
9) TONE ARM - This is a fully manual tone arm. To start playback, gently place the stylus on the record using the headshell
finger support. Do not drop the stylus onto the record as it may cause damage to the diamond tip or to the record.
10) PITCH SELECT - Press the button to select between +/-8% and +/-12% pitch range.
11) ANTI SKATE KNOB - When a record is playing, a force is generated drawing the stylus towards the center of the record.
Set this knob to the same value as the stylus pressure to offset this force.
12) COUNTERWEIGHT - Use this to balance the tone arm and to adjust the stylus pressure. See facing page for cartridge
settings for proper adjustments.
13) OUTPUT L & R - This is the standard analog output (RCA jacks) which can be connected either to a phono or line input
on any DJ mixer, depending on the setting of the phono/line selector. You can also plug straight into powered speakers
like the KRK Rokit series RCA input and setting the switch to line.
14) PHONO/LINE SWITCH - Switches the output to either phono or line level.
15) USB SOCKET- Connect the USB cable (included) to this socket and to a USB connector on your computer. After
connecting the turntable to your computer, you can record your vinyl to your hard disk using various recording
software programs.
Note: maximum USB cable length is 3m
16) DIGITAL OUTPUT - Use this output to connect your T.92 M2 USB to the S/PDIF digital input of any equipped digital
device, such as a CDR or computer.
17) POWER CORD CONNECTOR - Used to connect the included power cord.
18) POWER SWITCH - This switch turns the power on or off, including the motor and audio signal. Use this switch when the
unit will not be active for extended periods of time.