Delta 36-6023 Manual De Instrucciones página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

a
Level the throat plate to the table top using (4) flat head screws. See Figure 17 and 18. For more details about leveling throat plate,
see page 32.
To reduce risk of serious injury, do not attempt to secure the throat plate to the table using the throat plate
leveling screws.
To install throat plate, slip tab into slot at back of saw and push down to secure in place.
NOTE: There are four screws pre-assembled to the throat plate that can be used for leveling the throat plate if necessary. Turn
screws clockwise to raise the throat plate, counter clockwise to lower. Plate should be even or slightly below table surface. Plate
should not be above or more than 1/4 inch (0.7 MM) below the table on infeed side. On outfeed side plate should be below or no
more than 1/4 inch (0.7 MM) above the table.
ASSEMBLY
FIGURE 17
FIGURE 18
19

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido