Care And Cleaning; Troubleshooting - Glacier bay FW0AC000CP Guía De Instalación Y Cuidado

Care and Cleaning

□
To clean, wipe down with a damp cloth and towel dry.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.

Troubleshooting

NOTE: Refer to the service parts section in this manual
for a detailed drawing showing the location of the parts
listed below.
Problem
There are leaks from the
handle.
The aerator leaks or has a
reduced water flow.
The spout leaks.
The sink drain at the base of
the sink is leaking.
The water will not shut off
completely.
Possible Cause
□
The bonnet nut is loose.
□
The O-ring on the cartridge is
dirty or damaged.
□
The aerator is dirty or mis-fitted.
□
The cartridge may be clogged.
□
The retainer nut is loose.
□
The sink surface is rough or
irregular.
□
The locking nut is loose or
cartridge is not positioned
correctly.
Solution
□
Tighten the bonnet nut.
□
Clean or replace the O-ring.
□
Remove the aerator and check for
debris.
□
Remove the cartridge and check for
debris.
□
Ensure the aerator is properly
installed.
□
Tighten the retainer nut.
□
Apply additional silicone sealant to
the beveled side of the drain flange.
□
Retighten and test for leaks.
□
Remove the handle and cartridge to
check the rubber seat and spring.
□
Tighten the lock nut.
□
Clean or replace.
10