Troubleshooting Guide - NuTone LA225WH Manual De Instrucciones

MOUNT PUSHBUTTON
BLACK
"O" RING
MOUNTING
SCREWS
Refer to Figures 1 and 6.
1. After selecting usable locations in previous section, go to pushbutton
location.
2. Insert small, flat-blade screwdriver into bottom of pushbutton and twist
to separate its mounting base.
3. Make sure pushbutton mounting location is level.
4. Position pushbutton mounting base with "TOP" arrow correctly
oriented and mark base mounting holes locations.
5. Drill two (2) holes, 1/16" diameter if using supplied screws alone or
3/16" diameter if using supplied plastic anchors and screws, at base
mounting hole locations.
6. If 3/16" diameter holes were drilled, insert supplied plastic anchors.
7. Secure pushbutton base to mounting location with two (2) supplied
screws.
8. Make sure black O-ring is completely seated in its mounting base
groove with round edge at top and flat edge at bottom.
9. Hook pushbutton top catch onto top of base, swing pushbutton into
position and press bottom of pushbutton until it securely snaps onto
base.
MOUNT CHIME
Refer to Figure 7.
Chime may be used as a
portable device or wall
mounted.
1. After selecting usable locations
in previous section, go to chime
location.
2. Measure 1-7/8" down and
centered from top of chime
location and mark mounting
screw position.
3. Drill a hole, 1/16" diameter if
using supplied screw alone or
3/16" diameter if using supplied
plastic anchor and screw,
at marked mounting screw
location.
4. If 3/16" diameter hole was
drilled, insert supplied plastic
anchor.
5. Tighten screw until 1/8" remains
protruding.
6. Place chime keyhole slot over mounting screw.
7. Level chime.
T O P
PLASTIC

ANCHORS
BASE
Figure 6
1/8"
1-7/8"
KEYHOLE
CHIME
Figure 7

TROUBLESHOOTING GUIDE

1. Chime does not sound:
a. Check battery polarity.
b. Replace batteries in chime and pushbutton.
c. Bring chime next to wireless pushbutton and test:
1. If chime sounds then change mounting location of chime.
2. If chime does not sound then conduct erase procedure per note
at end of "Learn" Procedure then conduct "Learn" Procedure,
Steps 1 through 9.
2. Chime loses volume or changes tone: Change batteries in chime.
3. Chime sounds when wireless pushbutton is not pressed:
a. Release pushbutton catch at bottom and check inside for signs of
moisture; check O-ring for cracks or damage.
b. Conduct erase procedure per note at end of "Learn" Procedure
then conduct "Learn" Procedure, Steps 1 through 9.
The user is cautioned that changes or modifications not
expressly approved by the party responsible for regulatory
compliance could void the user's authority to operate this
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
SLOT
MODEL LA225WH
Regulatory Information
equipment.
Page 2