Setting Mode; Replacement Parts; Disposal Note - Grohe Ondus Manual Del Usuario

Under Calibrate in the chapter setting mode the fitting must to
be proportioned to the local circumstances:
• The display 38 °C must be synchronised with the measured
temperature.
• The minimum and maximum flow rate must be adjusted.
Thus changed the jet image.
Using the pre set panel
Hand washing
Face splashing
Teeth brushing
Memory button 1
Memory button 2
- Before using the pre set panel for the first time, it must
be connected to the operating panel in setting mode under
Wireless.
- The programs can be customised or changed in setting
mode under Preset.
- The bars on the display illustrate the chronological
sequence of the relevant program.

Setting mode

Setting mode is activated as follows:
1. Switch on the fitting via the
the temperature to 33 °C using the
2. Press the buttons in a clockwise sequence:
3. When, after pressing for the third time, the GROHE
Logo appears, confirm with the button.
Setting mode is now activated and Menu appears
in the display.
This is confirmed using the button on the operating panel.
Adjustment is made using the
mode by pressing the button.
The following settings can be changed using the operating
panel:
Clock (set time)
13:26 13:26
°C / °F (temperature unit conversion)
°C °F
Wireless (establish connection with pre set panel)
Press any program icon on the pre set panel and hold
for at least 4 s.
(numbers appear on the display if the connection
is successful)
Reset (reset factory settings)
Factory set? No Factory set? Yes
Saver (time until screensaver appears)
5 sec
Versions (show respective software version)
000 (operating panel)
000 (function unit)
000 (pre set panel)
button and set
button.
buttons. End setting
Visual (set colour of the temperature arrows)
Red/Blue Orange
Standby (select screensaver)
Off GROHE 13:26
Contrast (set background contrast)
12
Preset (program pre set panel)
Section 1 Flow
Time
Temp 38.0
Volume 1
Section 2
. . . .
. . . .
Section 7
Section 1
. . . .
. . . .
. . . .
Resume (time for pause mode)
60 sec
Protect (time for safety shut-off)
60 sec
Max (switching 43 °C stop on/off)
On Off
The display flashes if 43 °C is exceeded.
Optimal (define start temperature and volume rate)
First make settings in the Calibrate menu.
38 °C
Calibrate (adjust mixer unit)
Swap Hot Cold Swap Cold Hot
(connections interchanged)
38 °C | 0
Volume Min | 1 Volume Max | 30
Maintenance
Inspect and clean all components and replace if necessary.
Disconnect voltage supply.
Shut off hot and cold water supply.
Disconnect all plug-in connectors, see Fig. [9].
I. Change battery, see Fig. [10].
The battery must be replaced 10 years after commissioning
the fitting, at the latest.
II. Replace thermistor, see Fig. [11].
1. Disconnect plug-in connector (A).
2. Unscrew nut (B) and pull out thermistor (C).
III. Mousseur (48 009), see fold-out page I.
Install in reverse order.

Replacement parts

See fold-out page I (* = special accessories).

Disposal note

Dispose of batteries in accordance with national
regulations.
0
0
4