Cleaning And Maintenance - cecotec 3D FORCEANODIZED 950 SMART I-PUMP Manual De Instrucciones

ENGLISH
PRESSURE-GENERATING PUMP
• The iron includes a pressure pump to produce maximum steam and removes the most
difficult wrinkles. To activate it, press once the i-PUMP button located on the product's top
part. During operation, the LED will light and it will produce a slight sound. To turn it off,
press the button and wait until the light turns off.
SELF CLEANING
• Make sure the appliance is unplugged.
• Set the steam knob to "0".
• Fill the water tank up to the maximum mark and close it.
• Set the temperature knob to maximum.
• Connect the appliance to the power supply.
• Unplug the appliance when the indicator light turns off.
• Holding the iron horizontally, turn the steam controller to the maximum position and press
the self-cleaning button.
• Boiling water and steam will be ejected from the soleplate's holes, taking out all impurities.
• Repeat this process if considered necessary.
Tip: carry out the self-cleaning cycle once every 2 weeks. When excessive limescale is observed,
carry it out more frequently.
AUTO-OFF FUNCTION
The iron will automatically turn off when it is placed and kept still horizontally 25 seconds, or
vertically 8 minutes. The device will produce 6 beeps and the LCD display will light up in red,
indicating that the appliance has been turned off.
To heat it up again:
1. Lift or gently move the iron.
2. The LCD display will turn blue indicating that it is ready to be used.
ANTI-DRIP FUNCTION
• This function automatically prevents water from spilling when the appliance is not hot enough.
• During use, the anti-drip system may emit a loud clicking sound, especially during
preheating or whilst cooling down. This is perfectly normal and indicates that the system
is functioning correctly.
16 3D FORCEANODIZED 950 SMART I-PUMP
BUILT-IN ANTISCALE SYSTEM
• This system is designed to reduce the building up of limescale due to steam ironing. This
will lengthen the iron's shelf life.
CAUTION:
on the label means that this article may not be ironed.
Label indications Type of fabric
Nylon/synthetics
Wool/silk
Cotton
Linen

5. CLEANING AND MAINTENANCE

• Turn off, unplug the appliance from the power supply, empty the water tank and allow it to
cool down completely after each use.
• If there is any fabric adhered to the soleplate, use a damp cloth with vinegar to wipe off the
soleplate.
• Do not use abrasive scouring pads, powders or cleaners to clean the product.
• If scale blocks the steam holes, use a toothpick to remove it.
• To protect the soleplate while it is stored, place the steam iron in an upright position on its
heel rest.
6. TROUBLESHOOTING
Problem Possible cause
The temperature knob is
Not enough or too much
not set correctly or it is
heat.
unplugged.
The temperature knob has
No steam or leakage.
been set to MIN.
The steam-burst function
Steam burst or vertical has been used too often
steam do not work properly. within a very short period.
The iron is not hot enough.
ENGLISH
Temperature knob
MIN.
MAX.
Solution
Set the temperature knob
to the correct position.
Continue ironing in
horizontal position and
wait a while before using
the vertical steam-burst
function again.
3D FORCEANODIZED 950 SMART I-PUMP 17