Publicidad
Step 58
Step
The DOOR is not shown in this step.
å
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS into the hole locations of your choice
å
in the INNER RIGHT END (B3) and RIGHT UPRIGHT (E2). Set the ADJUSTABLE SHELF (Q) onto the METAL PINS.
NOTE: Before inserting the drawers, be sure the INNER CARTRIDGE in the EXTENSION RAILS on your unit is all the way
å
forward. The INNER CARTRIDGE should click into place against the BLACK TAB.
To insert the drawers into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS on the unit
å
and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the way in, then
it will slide in and out easier. Repeat this step for the KEYBOARD SHELF.
Insert the GROMMETS (10P) and GROMMET CAPS (1P) into the large holes in the TOPS (G2 and H2).
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
å
And to celebrate, why not share your success story?
Click the inner cartridge into place against the black tab.
Front
Black tab
Page 64
Inner cartridge
H2
70 lbs.
35 lbs.
Extension Rail
20 lbs.
5 lbs.
20 lbs.
1R
(4 used)
413670
KEYBOARD
DRAWER ON LEFT
G2
50 lbs.
5 lbs.
Q
E2
40 lbs.
2R
B3
www.sauder.com/services
1P
10P
25 lbs.
Publicidad
