Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
21. A close supervision is necessary when the hot plate is used by children. Never leave a switched on
appliance unattended.
22. This appliance can be used by children ages 8 and older and by the physically and mentally impaired or
by individuals with insuffi cient experience and knowledge, if supervised or trained to use the appliance in
a safe manner and understand potential dangers. Children shall not play with the appliance. Cleaning and
maintenance operations performed by the user shall not be carried out by children, if they are not older
than 8 years and under supervision. Children under the age of 8 shall keep away from the appliance and
its power supply.
OPERATING INSTRUCTIONS
Preparation before use
Before fi rst using the hot plates run it at the highest temperature for 3–5 minutes. You will thermally stabilize
the surface layer this way. After that never start the hot plate without a cooking vessel.
You will achieve the most eff ective operation when using cookware with fi rm fl at bottom with diameter
15–17 cm and about 1 l volume (on the smaller plate).
1.
Clean the hot plate using soft wet cloth. Place it on an even, stable surface close to the electrical outlet.
2.
Check if the voltage marked on the appliance corresponds to the voltage of your outlet. Before plugging
it in, make sure that the thermostat control is in the "MIN" position.
3.
When cooking, always use pots and pans with fl at bottoms that have close contact with the cooking plate.
Keep the surface of both hot plates clean and dry.
Operation
Used cookware should not have larger diameter than the diameter of the plate. The cookware used should
never extend to the area of control elements.
Using both plates in the same time
Note: Both plates can be used in the same time, but you have to be careful that the dishes do not extend
outside of the plates.
1.
Put food in the pot (the total amount of water and food in the pot should not exceed 80% of the volume of
the pot, to prevent overfl owing). Cover the pot with a lid and place it on the hot plate.
2.
Plug the hot plate in the outlet. The degree of heating can be controlled by turning the thermostat toward
the position MIN or MAX. Turn the thermostat control from the "MIN" position to maximum. The control
light comes on and the hot plate starts warming up.
3.
There are two points, which you have to remember when using new hot plate:
•
When using the new hot plate the fi rst time, the surface can emit odor or smoke. This is normal and it
is caused by an invisible layer of protective fi lm applied to the appliance during production.
•
Before the food starts to boil, the control light on the hot plate can go off temporarily because the
thermostat temporarily switches off . This safety feature is a normal function of the hot plate.
4.
When you fi nish cooking put the control in the MIN position and always disconnect from power
supply. Wait until the appliance cools off before moving it or cleaning it.
CLEANING AND MAINTENANCE
1.
Make sure that the power cable is unplugged. Clean the hot plate using gentle detergent or gel cleaner
and soft cloth after it thoroughly cools down.
DO NOT CLEAN THE APPLIANCE WHILE IT IS HOT.
2.
DO NOT USE hard brushes, abrasives or alcohol, kerosene or other organic cleaners.
3.
Do not immerse the hot plate in water while cleaning it.
4.
Store the hot plate in a cool place after cleaning.
Do not immerse in water!
GB
19
Publicidad
Tabla de contenido
