Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
...................... Class I Construction
(grounded)
.../min ..............per minute
BPM ....................beats per minute
IPM .....................impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM ....................strokes per minute
A .........................amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
WALL MOUNTING
The product can be attached to a wall to provide a
convenient storage and charging point for the appliance.
When mounting to a wall, make sure the mounting method
is suitable for the wall type and is appropriate to the weight
of the appliance.
•
Mark the location of the charger base
on the wall (within reach of an electrical outlet for
charging the vacuum while it is on the charging base).
•
Fix the charging base to the wall using appropriate
screws and plugs for the type of wall, and weight of the
appliance.
•
Hang the appliance by placing the opening of the
vacuum base over the hooks in the charging base.
Charging the battery
WARNING: For use only with the supplied charger.
•
Before first use, the battery must be charged for at least
6 hours.
•
HHVJ325B ONLY: Place the appliance on the charging
base
11
whenever it is not in use as shown in Figure B.
•
HHVJ315J, HHVJ325J ONLY: Plug the jack plug charger
into the charging socket of the tool as shown in
12
Figure C. Plug the charger into any standard 120 Volt 60
Hz electrical outlet.
WARNING: Before charging, be sure to empty all
contents and dry thoroughly if needed to avoid damage
to your appliance.
•
Make sure the appliance is switched off. The battery will
not be charged when the on/off switch
position.
nOTE: While charging, the charger may become warm. This
is normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely.
nOTE: The vacuum can not be charged while the pet head
is attached..
13
WARNING: Do not charge the battery at ambient
temperatures below 50 °F or above 104 °F.
...................... Class II
Construction
(double insulated)
n o .......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
screw holes
12
is in the on
1
Figure B
Figure C
Switching on and off - Figure D
•
HHVJ325B, HHVJ325J ONLY:
depress the on/off button
illuminate and vacuum will begin in the low-speed mode.
•
HHVJ315J ONLY: To switch the appliance on, depress the
on/off button (
). The vacuum will begin in the low-
1
speed mode.
nOTE: When battery life is nearly depleated, the battery
indicator LED will illuminate and flash.
•
Depress the button a second time to engage the
POWERBOOST mode. The green LED will also illuminate,
indicating the vacuum is in the higher-speed mode.
•
To switch the appliance off, depress the button a third time.
Figure D
POWERBOOST mode
The green LED will illuminate when the appliance is in
POWERBOOST mode. The vacuum will operate at a higher
suction level to pick up debris that requires more power.
English
To switch the appliance on,
1
. The battery indicator LED will
3
Publicidad
Tabla de contenido
